This seal, part number 021 117 151A, is for the oil cooler on the engine of a 71-83 Transporter & Vanagon. 2 of these are needed, except for the dual-port 71 Bus engine requires a total of 4 seals, as 2 more are needed for the oil cooler adapter. It fits 1971, 1972, 1973, 1974, 1975, 1976, 1977, 1978, 1979, 1980, 1981, 1982 and 1983 models.

This distributor drive gear spacer shim, part number 111105235A, is used in transporter models from 1955 to 1979.

2 needed

Fits 1955, 1956, 1957, 1958, 1959, 1960, 1961, 1962, 1962, 1964, 1965, 1966, 1967, 1968, 1969, 1970, 1971, 1972, 1973, 1974, 1975, 1976, 1977, 1978, 1979

This Viton seal, part number 021 109 345A, is the for the smaller diameter end of the pushrod tube where it meets the case on the engine of a 72-83 air-cooled Transporter & Vanagon. Viton rubber seals better and lasts longer. It fits 1972, 1973, 1974, 1975, 1976, 1977, 1978, 1979, 1980, 1981, 1982 and 1983 models.

This Viton seal, part number 021 109 349B, is the for the larger diameter end of the pushrod tube where it meets the head on the engine of a 72-83 air-cooled Transporter & Vanagon. Viton rubber seals better and lasts longer. It fits 1972, 1973, 1974, 1975, 1976, 1977, 1978, 1979, 1980, 1981, 1982 and 1983 models.

This flywheel bolt crush washer, part number 021 105 275, goes between the flywheel bolts and the flywheel on every 72-83 Type 2 Bus & Vanagon with an air-cooled type 4 engine and manual transmission. It fits 1972, 1973, 1974, 1975, 1976, 1977, 1978, 1979,1980, 1981, 1982 and 1983 models.

1 needed

This gasket, part number 021 115 487, seals the case breather to the engine case on every 1.7, 1.8 and 2 liter engine found in a 72-79 Bus.

This EGR filter gasket, part number 043131599A, fits Transporter models from 1975-1979 and Vanagon 1980-1983 with EGR valves. This gasket has one elongated bolt hole.

2 Needed

Fits 1975, 1976, 1977, 1978, 1979, 1980, 1981, 1982, 1983

This exhaust flange gasket, part number 025251261, is found on Transporter models from 1972-1979 as well as Vanagon 80-83 type 4 aircooled models.

2 needed

Fits 1972, 1973, 1974, 1975, 1976, 1977, 1978, 1979, 1980, 1981, 1982, 1983

This NGK spark plug, part number N 01781126, is for a 72-83 air-cooled Transporter or Vanagon. This comes with an unnecessary connector screwed on the top (where the plug wire goes on), so make sure to remove it before installation.

This part is no longer available. We are looking for a suitable alternative.

This official VW flywheel bolt is used to secure the flywheel on 72-83 Transporter and Vanagon models with type 4 aircooled engines.

5 needed

Fits 1972, 1973, 1974, 1975, 1976, 1977, 1978, 1979, 1980, 1981, 1982, and 1983 models.

This vacuum elbow, part number 022 129 637, connects the auxiliary air valve to a case breather hose on a 74-83 Type 2 Bus or Vanagon with an air-cooled engine. It fits 1974, 1975, 1976, 1977, 1978, 1979, 1980, 1981, 1982 and 1983 models.

This pushrod tube, part number 021 109 335C, is for the engine of a 72-83 Transporter & Vanagon. You will also need the large pushrod tube seal and small pushrod tube seal to install this. It fits 1972, 1973, 1974, 1975, 1976, 1977, 1978, 1979, 1980, 1981, 1982 and 1983 models.

This breather tube elbow, part number 021129637C, fits transporter models 1968-1979 as the intake manifold elbow for air vacuum and as the fuel tank breather outlet for 1972-1973 transporters.

1 needed

Fits 1972, 1973, 1974, 1975, 1976, 1977, 1978, 1979

This boot is for the oil pressure switch, part number 021119957, is used with 72-83 type 4 aircooled engines and seals the oil pressure switch to the engine tin improving cooling.

1 Needed.

Fits 1972, 1973, 1974, 1975, 1976, 1977, 1978, 1979, 1980, 1981, 1982, 1983

This fuel pump flange, part number 021127303A, fits type4 engine in transporter models from 72-74 with side mount. Often referred to as the fuel pump base.

1 Needed.

This rubber elbow that comes off the air cleaner, part number 021129639, is found on transporter models 1972-1979 and Vanagon 1980-1983 aircooled models.

1 Needed

Fits 1972, 1973, 1974, 1975, 1976, 1977, 1978, 1979, 1980, 1981, 1982, 1983

This gasket, part number 022 129 707F, goes between the intake manifold and the cylinder head on every 1.8L-2.0L 74-83 air-cooled Type 2 Bus or Vanagon engine. It fits 1974, 1975, 1976, 1977, 1978, 1979, 1980, 1981, 1982 and 1983 models.

This oil strainer (screen), part number 021 115 175, is for the engine of a 72-83 air-cooled Transporter & Vanagon. You should clean this with every oil change, and replace it if it's bent, torn, or you can't get it clean. You will also need the oil strainer gasket set to do your oil change.

This oil filter, part number 021 115 351A, is for a 1.7 liter, 1.8 liter, and 2 liter air-cooled engine found in a 72-83 Bus & Vanagon. We always recommend to clean your oil strainer while changing the oil, here are the seals and washer to do just that.

This official VW bolt, part number 001 199 103, goes in the upper hole of the starter and slides through the bell housing of the transmission and through the engine case to secure the starter and help hold the engine and transmission together, It is for every 76-83 Transporter & Vanagon.

This German-made Hella oil pressure switch, part number 021 919 081B, is for every 50-83 Type 2 Bus & Vanagon air-cooled engine. It's range is .15-.45 bar, The German Hella brand lasts a long time and gives the correct reading. This is a crucial part and worth the extra money. It fits 1950, 1951, 1952, 1953, 1954, 1955, 1956, 1957, 1958, 1959, 1960, 1961, 1962, 1963, 1964, 1965, 1966, 1967, 1968, 1969, 1970, 1971, 1972, 1973, 1974, 1975, 1976, 1977, 1978, 1979, 1980, 1981, 1982 and 1983 models.

This cap, part number 021 115 311, screws on to the oil filler neck where you pour oil into the engine. It fits 1972, 1973, 1974, 1975, 1976, 1977, 1978 and 1979 models.

This rear engine mount, part number 021199231C, fits transporter models 1972-1979 with type 4 engines.

2 Needed

Fits 1972, 1973, 1974, 1975, 1976, 1977, 1978, 1979

This socket, part number 021 129 957, is the swivel point for the carburetor linkage cross bar found on a 72-74 Type 2 Bus. It is German made to the exact specs as the original. It fits 1972, 1973 and 1974 models.

2 needed

This official VW gasket, part number 022 133 073A, goes between the throttle body and intake plenum on every 75-83 air-cooled Type 2 Bus or Vanagon. It fits 1975, 1976, 1977, 1978, 1979, 1980, 1981, 1982 and 1983 models.

This plastic timing scale, part number 021 119 249E, bolts above the pulley cover on 72-83 air-cooled Type 2 Bus & Vanagon models. This plastic version has the marks molded in so they remain legible even when dirty.

This boot, part number 021 903 655B, is for the air pushed out the back of a 55 amp alternator in a 72-79 Type 2 Bus. It fits 1972, 1973, 1974, 1975, 1976, 1977, 1978 and 1979 models.

This spring, part number 211 721 597D, connects to the carburetor to pull the accelerator pedal back up after being pressed down. This is for a 74-79 air-cooled Type 2 Bus with a carburetor.

1 needed

Fits 1974, 1975, 1976, 1977, 1978 and 1979 models.